ZyXEL Communications P-663H-51, User Manual

Page: 94 / 206

Chapter 9 Quality of Service (QoS)
P-663H-51 User’s Guide
94
Figure 51 Advanced > Quality of Service > QoS Classification
The following table describes the labels in this screen.
Table 37 Advanced > Quality of Service > QoS Classification
LABEL DESCRIPTION
Class Name This is the name of the classifier.
MARK These columns are the QoS setting the ZyXEL Device uses for or assigns to the
packets of upstream traffic that match this QoS classifier.
DSCP Mark This is the DSCP mark the ZyXEL Device assigns to the packets of upstream
traffic that match this QoS classifier.
Queue ID This is the QoS queue the ZyXEL Device uses for the packets of upstream traffic
that match this QoS classifier.
802.1P Mark This is the IEEE 802.1p mark the ZyXEL Device assigns to the packets of
upstream traffic that match this QoS classifier.
TRAFFIC
CLASSIFICATION
RULES These columns identify the upstream traffic to which the QoS classifier applies.
Lan Port This is the source Ethernet port of the traffic.
Protocol This is the type of packets.
DSCP This is the DSCP mark.
Source Addr./Mask This is the IP address (and optionally the subnet mask) of the device that sent
the traffic.
Source Port This is the port number that a device used to send the traffic.
Dest. Addr./Mask This is the IP address (and optionally the subnet mask) of the device that the
traffic is going to.
Dest. Port This is the port number on a device to which the traffic is going.
Source MAC Addr./
Mask This is the MAC address (and optionally the subnet mask) of the device that sent
the traffic.
Dest. MAC Addr./
Mask This is the MAC address (and optionally the subnet mask) of the device that the
traffic is going to.
802.1P This is the IEEE 802.1p mark on the traffic.
Order This is the classifier’s place in the classifiers list.
Enable / Disable The classifier is active when this check box is selected.
Remove To remove an entry, select its Remove check box and click the Remove button.
Add Click this button to go to a screen where you can configure settings for a new
QoS queue.
Remove To remove an entry select its Remove check box and click the Remove button.
Save/Apply Click this button to save the changes and have the ZyXEL Device start using
them.