omni.net LCD series Quick Start Guide
2-5
Install Drivers for Windows 2000
This section provides step by step procedures to install drivers needed for the omni.net USB
Terminal Adapter (TA) in Windows 2000. Install your TA via a USB interface or a serial port
(RS-232) interface.
1.
Install your TA via a USB Interface
.
This is the most typical installation.
2.
Install your TA via a Serial Port (RS-232) Interface
.
This installation requires you to restart your computer.
1. Install your TA via a USB Interface.
Step 1.
Connect your USB cable to your omni.net LCD PLUS and computer. Make sure your
TA is on. Windows should automatically detect that you have a new device and will give
you the following Wizard window.
Step 2.
If you see the
Found New Hardware Wizard
window shown below then please
continue by following the instructions in
Step 3
. If you do not see the
Found New
Hardware Wizard
window below then click
Start
,
Settings
,
Control Panel
, double
click the
Add New Hardware
icon and follow your computers’ prompts until your TA is
detected by your computer.
Step 3.
Follow the instructions below.
Click
Next >
to
start the
Hardware
Wizard
.
