ZyXEL Communications OMC-2301, User Manual

Page: 43 / 224

OMC-2301 User’s Guide
43
C
H A P T E R
4
Initial Setup Example
This chapter shows how to set up the OLT to provide Internet access to an ONU using the
default service profiles.
4.1 Overview
You need to test the connection between an ONU and the OLT in your network before
deploying your PON. You should already have a network with Internet access, a DHCP server
and a Gigabit switch.
In this example, you set up a simple PON network using an OLT, an ONU and a computer.
Once connected, the default profile settings on the OMC allow you to access the Internet
through the ONU. For the test network, you create a service profile on the OMC with the pre-
defined 100Mbps bandwidth limit and apply it to the ONU.
Figure 11 Initial Setup: Network Example
The following outlines the procedure for the initial setup.
• Connect the devices to set up a simple network.
• Create a service profile with the pre-defined bandwidth setting.
• Test the Internet connection from the ONU.
4.2 Connecting the Devices
Follow the steps below to connect the devices for the simple test network.
1 Insert an OLC-2301 in the first slot of the OLT 2300.
2 Connect the Gigabit Ethernet port on the OLC-2301 to a Gigabit port on a switch that
has access to the Internet.
PON 1
Ethernet 1
Internet
MGMT
OLT
ONU