ZyXEL Communications MSC1000G Series, User Manual

Page: 991 / 1168

Chapter 33 switch Commands
Management Switch Card User’s Guide
991
33.4 switch bandwidth Commands
Use the
switch bandwidth
commands to configure bandwidth control.
33.4.1 switch bandwidth disable Command
Syntax:
switch bandwidth enable < giga-port >
where
This command turns on bandwidth control on the specified Gigabit Ethernet interface (or all of
them).
This example turns off bandwidth control for the uplink 1 port.
33.4.2 switch bandwidth enable Command
Syntax:
switch bandwidth enable < giga-port >
vcc < giga-
port >|< slot-port >
< high-limit > < low-
limit >
Sets a transceiver’s voltage thresholds. When the
value goes out of the thresholds, the system
sends an alarm.
high-limit
: high threshold, 0~6.5535
low-limit
: low threshold, 0~6.5535. The value
must be smaller than the
high-limit
value.
8
vlanpri disable
Turns off assigning of priority to traffic based on
its VLAN. 8
enable
Turns on assigning of priority to traffic based on
its VLAN. 8
delete <vid>
Removes the VLAN-based priority setting for the
specified VLAN ID. 8
set <vid> < priority >
Has the system assign the specified priority to
traffic with the specified VLAN ID. 8
show [vid]
Displays the current setting for VLAN-based
priority or the VLAN-based priority setting for a
specific VLAN ID. 1
Table 386
switch Commands (continued)
COMMAND DESCRIPTION P
< giga-port >
=
This represents Gigabit Ethernet uplink ports, subtending ports or all ports. Use
sub1|sub2|up1|up2|all i
f trunking is not enabled. Use
sub|up|all
if trunking is enabled.
ras> switch bandwidth disable up1