ZyXEL Communications MSC1000G Series, User Manual

Page: 797 / 1168

Chapter 29 port Commands
Management Switch Card User’s Guide
797
where
This command deletes the specified PVC channel in an IP bridge.
The following example deletes the IP bridge PVC on ADSL port 10 with VPI 40, VCI 73.
29.19 IP Bridge Domain Commands
Use these commands to set up and maintain domains in IP bridges.
A domain represents an ISP. Each domain is defined by (and dominates) the VLAN that are in it and
has its own routing table and ARP table. As a result, two or more VLANs in different domains can
use the same IP subnet, and one network can support multiple ISPs.
VLANs in IP bridges are exclusive. They can be in at most one domain. In addition, VLANs in IP
bridges share the same VLAN space as regular VLANs, so VLANs in IP bridges must have different
VLAN IDs than regular VLANs.
29.19.1 port ipbpvc domain delete Command
Syntax:
port ipbpvc domain delete < domain name >
where
This command deletes the specified domain.
Note: You have to remove the VLANs that are in the domain first.
29.19.2 port ipbpvc domain dhcpvlan enable Command
Syntax:
port ipbpvc domain dhcpvlan enable < domain name > < vid >
vpi/vci =
The VPI and VCI of an individual PVC.
ras> port ipbpvc show 1-10
pvc type pvid pri ipbpvctype profile
--------------- ------- ---- --- ---------- ----------------------------------
1-10-40/73 ipb 402 2 llc DEFVAL
ras> port ipbpvc delete 1-10-40/73
ras> port ipbpvc show 1-10
ras>
< domain name > =
The name of the domain.