ZyXEL Communications MSC1000G Series, User Manual

Page: 721 / 1168

Management Switch Card User’s Guide
721
C
H A P T E R
2 5
ip Commands
Here is how to use the
ip
commands to configure the IP (Internet Protocol) version 4 parameters.
Note: The ip commands are for management purposes, rather than for user traffic.
25.1 ip Commands Summary
The following table lists the
ip
commands. The P column on the right indicates the administrator
privilege level needed to use the command.
Table 357
ip Commands
COMMAND DESCRIPTION P
ip arp flush
Clears the device’s IP Address Resolution
Protocol (ARP) table. 8
show
Displays the device’s IP ARP table. 1
gateway < ip-address >
Sets the default gateway IP address. 8
ping < ip-address >
[-l < size >] [-
n < count > |-t]
Pings a host (default 3 times)
size
: 0-1472 bytes
count
: number of pings.
-t
: continously send pings to the destination
until you press Ctrl-C.
1
route delete < dst-ip >[/< netmask >]
< gateway-ip >
Removes a routing table entry. 8
set < dst-ip >[/< netmask >]
<gateway-ip>
[< metric >] [< name >]
Adds or modifies a route entry.
gateway-ip :
a gateway IP address of
‘0.0.0.0/0’ means a default gateway.
8
show
Displays the routing table. 1
show
Displays the IP addresses of the in-band and
out-of-band management interfaces and the
default gateway, as well as the in-band
management VLAN ID. 1