ZyXEL Communications MSC1000G Series, User Manual

Page: 358 / 1168

Chapter 11 Profile Screens
Management Switch Card User’s Guide
358
N-wire mode can increase the reach of a particular data rate without having to regenerate the
signal. It can also give increased bandwidth for LAN-to-LAN applications.
You can n-wire bundle multiple groups of ports on a single SHDSL line card.
11.10 SHDSL Profile Screen
Click Profile > SHDSL in the navigation panel to open the following screen. Use this screen to
configure SHDSL profiles. Later you can apply the SHDSL profiles to configure SHDSL ports in the
SHDSL Port Setup screens.
Figure 229
SHDSL Profile
The following table describes the fields in this screen.
Table 168
SHDSL Profile
LABEL DESCRIPTION
The top part of the screen is for profile configuration.
Name When editing a profile, this is the name of this profile. When adding a profile, type a name
(up to 31 characters) for the profile.
Max Rate
[192~5696]
kbps Type a maximum transfer rate for this profile.
Min Rate
[192~5696]
kbps Type the minimum upstream transfer rate for this profile. The SHDSL connection will not
come up if you set this higher than the lowest speed the link can reach.
Annex Mode Select the region setting.
Select ANNEX_A to use DSL over POTS.
Select ANNEX_B to use DSL over ISDN.