ZyXEL Communications MGS-3712, User Manual

Page: 79 / 308

Chapter 7 Basic Setting
MGS-3712/MGS-3012F User’s Guide
79
7.7 Port Setup
Use this screen to configure Switch port settings.Click Basic Setting > Port Setup in the
navigation panel to display the configuration screen.
Figure 38 Basic Setting > Port Setup
IP Address Enter the IP address for managing the Switch by the members of the VLAN
specified in the VID field below.
IP Subnet Mask Enter the IP subnet mask in dotted decimal notation.
VID Type the VLAN group identification number.
Default Gateway Enter the IP address of the default outgoing gateway in dotted decimal notation.
Add Click Add to insert the entry to the summary table below and save your changes
to the Switch’s run-time memory. The Switch loses these changes if it is turned
off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This field displays the index number of the rule. Click an index number to edit
the rule.
IP Address This field displays the IP address.
IP Subnet Mask This field displays the subnet mask.
VID This field displays the ID number of the VLAN group.
Default Gateway This field displays the IP address of the default gateway.
Delete Check the management IP addresses that you want to remove in the Delete
column, then click the Delete button.
Cancel Click Cancel to clear the selected checkboxes in the Delete column.
Table 11 Basic Setting > IP Setup (continued)
LABEL DESCRIPTION