MC1000-SFP User’s Guide
12
DIP
Switch 1
The fiber link is auto-negotiating when the switch is off. Turn it
on to force the fiber link to be up at only 1000Mbps in full
duplex mode.
DIP
Switch 2
Turn this switch on to have the Ethernet port send a Link Loss
Forwarding message to the fiber port in the event that the
Ethernet link goes down (that would then force the fiber link
down).
DIP
Switch 3
Turn this switch on to have the fiber port send a Link Loss
Forwarding message to the Ethernet port in the event that the
fiber link goes down (that would then force the Ethernet link
down).
Do not turn a DIP switch on or off when a port is transmitting
or receiving data as it may cause data error or loss.
SFP Transceiver Slot
Insert a 3.3V SFP (Small Form-factor Pluggable) transceiver module
with an LC-type connector into the SFP slot.
Use DIP switch 1 to change the default fiber connection
settings.
SFP transceiver modules are static sensitive. To prevent damage from
electrostatic discharge (ESD), it is recommended you attach an ESD
preventive wrist strap to your wrist and to a bare metal surface when
you install or remove an SFP transceiver module.
SFP transceiver modules are dust sensitive. Avoid getting dust and other
contaminants into them.
SFP transceiver modules are equipped with a Class 1 laser, which emits
invisible radiation. To avoid possible eye injury, do not look into an
operating fiber-optic module’s connectors. Laser radiation is also
present when the media converter is turned on.
Installing and Removing a Module
