ZyXEL Communications MAX318M2W, User Manual

Page: 103 / 294

Chapter 7 Network Settings
MAX318M2W User’s Guide
103
This screen contains the following fields:
7.13 RIP
Use these settings to configure how the WiMAX Device exchanges information with
other routers.
Click Network Setting > Route > RIP to open this screen as shown next.
Figure 45 RIP Screen
Table 35 Static Route
LABEL DESCRIPTION
Destination IP Enter the destination IP address of the static route.
Subnet Mask Enter the subnet mask of the static route.
Next Hop Select Interface and then select WAN or LAN for the next hop of the
static route.
If the next hop is an IP address rather than an interface on the WiMAX
Device, select IP Address and enter the IP address.
Metric Enter the static route metric.