IES-5000 Support Notes
All contents copyright (c) 2006 ZyXEL Communications Corporation.
9
CI command:
TGE1> switch port pvid up1 200
TGE1> switch port pvid up2 200
TGE1> port pvc set 7-1-0/33 DEFVAL llc 10 0
TGE1> port pvc set 7-2-0/33 DEFVAL llc 20 0
1.3 Port Isolation
If we just want to isolate ports of IES-5000 and don’t want to set any VLAN, there is
another easy way to do this, setup
Port isolation.
CI command:
TGE1> switch isolation enable
2. Prestige 660R-61(P791) Settings
Please refer to the procedures in previous application.
Triple play Application
The IES-5000 allows you to use different channels (also called Permanent Virtual
Circuits or PVCs) for different services. Define channels on each DSL port for
different services and assign each channel a priority, a VLAN and ATM Quality of
Service (QoS). The ATM QoS allows you to regulate the average rate and fluctuations
of data transmission. This helps eliminate congestion to allow transmission of real
time data (such as audio and video).
In this application, we demonstrate how to set up the multiple PVCs environment.
From the figure below, the PC wants to access the two kinds of network services. One
is the Internet service (data service) and the other is Video service. Because we hope
we can see the video smoothly, we need to set the video service higher priority. In
IES-5000, we can set the two services with different VLANs and assign the PVCs
with different VLAN, priority and ATM QoS. That will make the video traffic get the
higher priority than data traffic. We also can expand this application to triple play
