ZyXEL Communications IES-1248-71, User Manual

Page: 392 / 464

Chapter 55 ADSL Commands
IES-1248-71/73 User’s Guide
392
This command configures settings and thresholds that define when the IES-1248 is to send an
alarm trap and generate a syslog entry.
Configure alarm profiles first and then use the
alarmprofile map
command to set the
IES-1248 to use them with specific ADSL ports.
The following example sets an alarm profile named
SESalarm
that has the IES-1248 send an
alarm trap and generate a syslog whenever the upstream connection’s number of severely
errored seconds exceeds three within a 15 minute period.
55.3.3 Alarm Profile Delete Command
Syntax:
ras> adsl alarmprofile delete <profile>
where
This command allows you to delete an individual ADSL alarm profile by its name. You cannot
delete the DEFVAL alarm profile.
The following example deletes the
SESalarm
alarm profile.
55.3.4 Alarm Profile Map Command
Syntax:
ras> adsl alarmprofile map <portlist> <profile>
where
Sets the IES-1248 to use an (already-configured) alarm profile with the specified ADSL ports.
<atuc ses>
<atur ses> =
The number of Severely Errored Seconds that are permitted to
occur within 15 minutes.
<atuc uas>
<atur uas> =
The number of UnAvailable Seconds that are permitted to occur
within 15 minutes.
Figure 259 Alarm Profile Set Command Example
ras> adsl alarmprofile set SESalarm 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2 0 3
0 0 0
<profile> =
The name of an alarm profile.
Figure 260 Alarm Profile Delete Command Example
ras> adsl alarm profile delete SESalarm
<portlist> =
You can specify a single ADSL port <1>, all ADSL ports <*> or a list of
ADSL ports <1,3,5>. You can also include a range of ports <1,5,6~10>.
<profile> =
The name of an alarm profile.