ZyXEL Communications IES-1248-51A, User Manual

Page: 487 / 654

Chapter 64 ADSL Commands
IES-1248-51V User’s Guide
487
adsl linediag setld < port >
Performs line diagnostics on the specified port. The
ADSL port must be set to ADSL2 or ADSL2+ ADSL
operational mode and have a connection. It takes
about one minute for the line diagnostics to finish. H/H
adsl linediag getld < port >
Displays the line diagnostics results after using the line
diagnostics set command on an ADSL port. Use the
line diagnostics results to analyze problems with the
physical ADSL line.
Note: Wait at least one minute after using the line
diagnostic set command before using this
command.
L/L
adsl linediag getld992-3 < port >
Displays the line diagnostics results in the format
defined in the ITU-T G.992.3 standard after using the
line diagnostics set command on an ADSL port. Use
the line diagnostics results to analyze problems with
the physical ADSL line.
Note: Wait at least one minute after using the line
diagnostic set command before using this
command.
L/L
adsl linediag setselt < port >
Performs a single end line test on the specified port.
This test checks the distance to the subscriber’s
location.
Note: The port must have an open loop. There
cannot be a DSL device, phone, fax machine
or other device connected to the subscriber’s
end of the telephone line.
H/H
adsl linediag getselt < port >
Displays the status and the results of the SELT test on
the specified port. The report tells you what gauge of
telephone wire is connected to the port and the
approximate length of the line measured both in
meters and thousands of feet. L/L
adsl linediag toneDiag < port >
Displays the tone diagnostics for a port in the format
defined in the ITU-T G.992.3 standard. You do not
need to use the line diagnostics set command first. Use
the tone diagnostics to analyze problems with the
physical ADSL line. L/L
adsl ipbpvc arpproxy agingtime
set < sec >
Sets the valid time interval of a learned MAC address.
10~10000 seconds. H/H
adsl ipbpvc arpproxy agingtime
show
Display the current time interval of a learned MAC
address. M/L
adsl ipbpvc arpproxy flush all |
edgerouter [< ip >< vid >]| interface
[< ip >/< mask >< vid >]
Flush the learned MAC addresses manually. H/H
Table 186 ADSL Statistics Commands (continued)
COMMAND DESCRIPTION P