ZyXEL Communications IES-1248-51A, User Manual

Page: 457 / 654

Chapter 62 IP Bridge Commands
IES-1248-51V User’s Guide
457
which the IES-1248-51V should forward traffic for a particular destination IP
address or IP subnet.
62.4.1 IP Bridge Route Set Command Example
The following example creates an entry in the routing table for domain
“example3”. This entry forwards traffic for IP addresses
192.168.4.0~192.168.4.255 to edge router 192.168.1.244.
Table 176 IP Bridge Routing Table Commands
COMMAND DESCRIPTION P
adsl ipbpvc route set
< domain-name > < ip-address >/
< mask-bits > < nexthop >
< metric > [< priority >]
This command creates the specified entry in the routing
table of the specified domain.
The
< ip-address >/< mask-bits >
specifies the range of IP
addresses to which this entry applies. If the destination IP
address of a packet is in this range, the IES-1248-51V
forwards the frame to the specified IP address
<nexthop>
.
If
<nexthop>
corresponds to an edge router configured
using the edge router commands (see Section 62.3 on
page 455 ), the IES-1248-51V uses the associated VLAN
ID. In addition,
If the edge router is in the same domain as the entry, the
entry is used for upstream traffic.
If the edge router is in a different domain than the entry,
the entry is used for downstream traffic.
If
<nexthop>
is not set up in the edge router screen, the
IES-1248-51V uses the entry for downstream traffic and
does not change the VLAN ID.
If the
<priority>
is not specified, the default value is
zero. This is applied to incoming frames without a
<priority>
tag.
H/H
adsl ipbpvc route show
[<domain name> | < ip-
address >/< mask-bits > |
< domain-name > < ip-address >/
< mask-bits >]
This command displays routing table entries created
manually for the specified domain and/or range of IP
addresses. It does not show entries added automatically
by the IES-1248-51V. M/L
adsl ipbpvc route runtime
[< domain-name > | < ip-
address >/< mask-bits > |
< domain-name > < ip-address >/
< mask-bits >]
This command displays the (run-time) routing table(s) for
the selected domain or range of IP addresses. This table
includes all the entries, whether added automatically by
the IES-1248-51V or provided manually. M/L
adsl ipbpvc route delete
< domain-name > < ip-address >/
< mask-bits > < nexthop >
This command deletes the specified entry from the routing
table of the specified domain. You can only remove entries
that were added manually. H/H
ras> adsl ipbpvc route set example3 192.168.4.0/24 192.168.1.244 1