ZyXEL Communications IES-1248-51A, User Manual

Page: 442 / 654

Chapter 60 Switch and Statistics Commands
IES-1248-51V User’s Guide
442
60.2 DSCP Commands
The following table describes the
dscp
commands. Use these commands to
configure the DiffServ Code Point settings of the IES-1248-51V’s ports.
60.3 Ethernet Commands
The following table describes the
enet
commands. Use these commands to
configure the settings of the IES-1248-51V’s Ethernet ports.
switch dot1x radius port
< port >
Sets the RADIUS server port. H/H
switch dot1x radius secret
< secret >
Sets the RADIUS server secret. H/H
switch dot1x radius show
Displays RADIUS server settings. M/L
switch dot1x show [ portlist ]
Displays IEEE 802.1x settings. M/L
statistics dot1x [ portlist ]
Displays the IEEE 802.1x information for the
specified port(s). M/L
Table 164 IEEE 802.1x Commands (continued)
COMMAND DESCRIPTION P
Table 165 DSCP Commands
COMMAND DESCRIPTION P
switch dscp disable <portlist>
Disables DSCP mapping on the specified xDSL
or Ethernet port(s). M/
H
switch dscp enable < portlist >
Enables DSCP mapping on the specified xDSL
or Ethernet port(s). M/
H
switch dscp map set < srccp >
< mappri >
Configures the DSCP-to-802.1p mapping
table.
srccp
: source code point (0~63). For
example,
1
,
3~5
,
10~15
).
mappri
: mapping priority (0~7).
M/
H
switch dscp map show
Displays the DSCP-to-802.1p mapping table. L/L
switch dscp show [portlist]
Displays the DSCP setting for the specified
port(s). L/L
Table 166 Enet Commands
COMMAND DESCRIPTION P
switch enet disable < portlist >
Turns off the specified Ethernet port(s). H/H
switch enet enable < portlist >
Turns on the specified Ethernet port(s). H/H