Chapter 5 WAN Setup
P-793H User’s Guide
84
5.5.2 Configuring More Connections Advanced Setup
Use this screen to edit your ZyXEL Device's advanced WAN settings. Click the
Advanced
Setup
button in the
More Connections Edit
screen. The screen appears as shown.
Figure 31
WAN > More Connections > Advanced Setup
The following table describes the labels in this screen.
Table 20
WAN > More Connections > Advanced Setup
LABEL
DESCRIPTION
RIP & Multicast
Setup
RIP Direction
RIP (Routing Information Protocol, RFC 1058 and RFC 1389) allows a router to
exchange routing information with other routers. The
RIP Direction
field controls
the sending and receiving of RIP packets. Select the RIP direction from
Both
/
In
Only
/
Out Only
/
None
. When set to
Both
or
Out Only
, the ZyXEL Device will
broadcast its routing table periodically. When set to
Both
or
In Only
, it will
incorporate the RIP information that it receives; when set to
None
, it will not send
any RIP packets and will ignore any RIP packets received.
RIP Version
This field is enabled if
RIP Direction
is not
None
. The
RIP Version
field controls
the format and the broadcasting method of the RIP packets that the ZyXEL Device
sends (it recognizes both formats when receiving).
RIP-1
is universally supported
but RIP-2 carries more information. RIP-1 is probably adequate for most networks,
unless you have an unusual network topology. Both
RIP-2B
and
RIP-2M
sends the
routing data in RIP-2 format; the difference being that
RIP-2B
uses subnet
broadcasting while
RIP-2M
uses multicasting. Multicasting can reduce the load on
non-router machines since they generally do not listen to the RIP multicast address
and so will not receive the RIP packets. However, if one router uses multicasting,
then all routers on your network must use multicasting, also.
Multicast
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a multicast group. The ZyXEL Device supports both IGMP
version 1 (
IGMP-v1
) and
IGMP-v2
. Select
None
to disable it.
ATM QoS
ATM QoS Type
Select
CBR
(Constant Bit Rate) to specify fixed (always-on) bandwidth for voice or
data traffic. Select
UBR
(Unspecified Bit Rate) for applications that are non-time
sensitive, such as e-mail. Select
VBR
(Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
Summary of Contents for G.SHDSL.bis 4-port Security Gateway P-793H
