ZyXEL Communications G-302 V3, User Manual

Page: 45 / 81

ZyXEL G-302 v3 User’s Guide
Chapter 3 ZyXEL Utility Configuration 41
3.2.2.3 WPA-PSK/WPA2-PSK
Note: You can use WPA and WPA2 with the G-302 v3 only in Microsoft Windows XP,
Windows Vista and Windows 2000.
Figure 17 Security Settings: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
PEAP Inner EAP This field is only available when you select PEAP in the Authentication Type field.
Select a PEAP protocol. Options are TLS and MS CHAP-V2 .
TTLS Inner
authentication
This field is only available when you select TTLS in the Authentication Type field.
Select a TTLS protocol that the RADIUS server uses. Options are CHAP , MS
CHAP , MS CHAP-V2 and PAP .
Back Click Back to go to the Site Survey screen to select and connect to other network.
Next Click Next to confirm your selections and advance to the Confirm Save screen.
Refer to Section 3.2.3 on page 42 .
Exit Click Exit to return to the Site Survey screen without saving.
Table 7 Security Settings: WPA/WPA2
LABEL DESCRIPTION
Table 8 Security Settings: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Encryption Type The encryption mechanisms used for WPA/WPA2 and WPA-PSK/WPA2-PSK are
the same. The only difference between the two is that WPA-PSK/WPA2-PSK uses
a simple common password, instead of user-specific credentials.
Select the encryption type (
TKIP or AES ) for data encryption.
Refer to Section 2.2.3 on page 31 for more information.
Pre-Shared Key Type a pre-shared key (same as the AP or peer device) of between 8 and 63 case-
sensitive ASCII characters (including spaces and symbols).
Back Click Back to go to the Site Survey screen to select and connect to other network.
Next Click Next to confirm your selections and advance to the Confirm Save screen.
Refer to Section 3.2.3 on page 42 .
Exit Click Exit to return to the Site Survey screen without saving.