B-6010/B-6020 Secure Outdoor Ethernet Radio Link
8
should be the same, otherwise, the installation will fail to communicate. At the same time, you have to position
the directional antenna to each other for both sides mutually.
Notice: The antenna must be installed by the professional installer to comply with the safety, electrical and
radiation standards. The installer should properly configure the output power of transceiver in
according to related country regulation requirement and per antenna type.
Figure 4-6 Install Antenna to the Outdoor Unit
7.
Attach the end of 8-pin male connector of category 5 cable to the 8-pin female connector port labeled
on
the bottom of outdoor unit.
Figure 4-7 Connect Cat-5 cable to the outdoor unit
Well done! The outdoor unit installation is completed.
4.3. Indoor
Unit
Installation
The indoor unit installation is to be proceeded after the outdoor installation.
1.
Choose an appropriate place for the network/power injector. You might hang it on the wall or just place it on the
desk.
2.
Connect the other end of category 5 cable to the RJ-45 connector labeled
TO RADIO
of network/power
injector.
3.
Connect one end of Ethernet cable to the RJ-45 port labeled
TO LAN
on the network/power injector. Connect
the other end of Ethernet cable to the workstation directly or through a switch/hub/router (iAIR M9000 only).
4.
Connect the power jack of switching power adaptor to the power port labeled
POWER
on the network/power
injector.
