ZyXEL Communications AAM1212-51, User Manual

Page: 43 / 435

AAM1212-51/53 Series User’s Guide
Chapter 3 Front Panel 43
C
H A P T E R
3
Front Panel
This chapter describes the front panel and rear panel of the AAM1212 and shows you how to
make the hardware connections.
3.1 Front Panel
The figure below shows the front panel of the AAM1212.
Figure 7 Front Panel
3.1.1 Front Panel Ports
The following table describes the port labels on the front panel.
3.1.2 LEDs
The following table describes the LED indicators on the AAM1212.
Table 1 Front Panel Ports
LABEL DESCRIPTION
CONSOLE Only connect this port if you want to configure the AAM1212 using the command line
interface (CLI) via the console port.
LAN 10/100 Connect these ports to a computer, a hub, an Ethernet switch or router.
USER/CO Connect the Telco-50 connector USER pins (14-25, 39-50) to subscribers respectively.
Connect the Telco-50 connector CO pins (1-12, 26-37) to the telephone company for
subscribers respectively.
Table 2 LEDs
LED COLOR STATUS DESCRIPTION
ALM Red On There is a hardware failure.
Off The system is functioning normally.