1
3
4
2
Ensure that your Apex
Gateway (Zyxel 3415) is set
up and your Wi-Fi is active. If
you are using Fioptics Internet
today, this is likely complete.
If you are installing new
Fioptics Internet service as
well, follow the instructions
with your Apex gateway before
proceeding.
Now, locate your Fioptics remote and proceed to step
“A”
to program this remote to your
set-top box.
Take your Atom DVR set-top box and place
it close to your TV. Allow at least 7 feet
between Atom and your Apex gateway to
ensure the best quality.
Connect your Atom DVR set-top box to your
TV using either an HDMI or A/V cable.
Plug the power adapter into an outlet. Your
set-top box will begin to power up.
Power on your TV, then select input / source
button using your TV remote. You will see
the Network Setup screen, and can proceed
to step 3.
Locate Your
Gateway
Network Setup
Connect the TV
WPS
WPS
ZyXel 3415
POWER
WAN
INTERNET
USB
W
I
F
I
2.4G
W
I
F
I
5G
ETHERNET
1
2
3
4
2.4G
5G
WAN
INTERNET
USB
W
I
F
I
2.4G
W
I
F
I
5G
ETHERNET
1
2
3
4
2.4G
5G
POWER
1
2
3
4
2.4G
5G
POWER
RESET
USB
WA
N
12VDC 2.5A
ETHERNET
WAN
ETHERNET
Apex Gateway
(Zyxel 3415)
RESET
POWER
WPS
A/V OUT
HDMI
USB
LAN
DIGITAL
AUDIO
RESET
POWER
WPS
A/V OUT
HDMI
USB
LAN
DIGITAL
AUDIO
Network Setup
Select connection type
Wired (Ethernet)
Network Status
Exit
Wireless (Wi-Fi)
Network Setup
Initiate wireless connection setup
Start WPS
Available Networks
Back
Apex Gateway
(Zyxel 3415)
WAN
INTERNET
USB
WIFI 2.4G
WIFI 5G
ETHERNET
1
2
3
4
2.4G
5G
POWER
WPS
WPS
WPS
WPS
Return to your TV and wait for wireless connection, which can take a few minutes. Once connected,
you will see “Connection successful” on your TV screen. Select “Finish” by pressing OK button on your
Fioptics remote. Next, your set-top box will go through a firmware update. Do not press any buttons
during this update. Once update is complete, your set-top box will reboot and your Fioptics TV service
is now active.
You will still need to program your Fioptics remote to your TV. To do so, please follow the instructions
included with your Fioptics remote.
Connect using HDMI cable
Connect using A/V cable
or
Use these same instructions to connect the remainder of your set-top boxes to the other TVs in
your home, following steps 2 and 3.
Go to your Apex Gateway, press and hold the
WPS button for 3 seconds until it flashes
orange.
Now, using your remote, select “Start WPS”
on your TV screen.
B
C
To program your Fioptics remote to your set-top
box, press then hold SETUP button and button
at the same time until blinks twice. Then, using
your remote, from the Network Setup screen,
choose the connection type “Wireless Wi-Fi” by
pressing OK button.
A
