Network Speaker User Guide | ZYCOO Co., Ltd.
16
Upgrade
To upgrade the network speaker’s firmware, please go to Settings
-> Upgrade page.
You’ll first see the current firmware version of the ne
twork speaker and the last upgrade time.
Upload the .img file provided by ZYCOO to perform the upgrade action. If you wish to reset the network
speaker to factory defaults after upgrading, please enable the “Reset Factory Defaults” parameter.
It will take around 2 minutes to complete the firmware upgrade, during upgrading process please DO NOT
power off the network speaker.
Reboot & Reset
The network speakers can be rebooted and reset from the web management interface on the Settings ->
Reboot & Reset page.
Both reboot and reset action will terminate all broadcasting and SIP calls (paging). And the reset action will
erase all configurations of the network speakers. Please reboot or reset the devices when they are not in use.
Except resetting from web management interface, the network speakers can be also reset by the RST button
on the rear panel of the speakers. Press and hold the RST button for 10 seconds (5 seconds for IP address
announcements) and release, now you should hear voice prompts “Resetting factory defaults, rebooting…”, it
means the speaker will now reset.
