ZM111317
7
Figure 2-6
2.4
RESET and SD Card Installation (Network Speed Dome) IP
Open the rear cover and you can see there is a reset button and a SD card slot on the PTZ
mainboard (see Figure 2-7). The reset button is used to reset network system and SD card is
used to store data.
Figure 2-7
2.5
Cable Connection
Please connect the power cable, video output cable, audio cable, RS485 control cable, alarm
input/output pin, network cable, and high-frequency cable according to your actual requirements.
Please use insulation tape to seal the cable connection ports for proper waterproofing.
Note
The video port is covered with heat shrink tube of high shrinking ratio. After the video connection,
please heat the tube to make sure the video port is damp proof and waterproof.
