3
Screen Icons
3. Connect the network and power as shown below:
Note:
The IP phone should only be used with a ZULTYS 5V DC power adapter. The use of a third-party power
adapter may cause damage to the phone. If you are connecting a PC to the Network port of the phone,
it is recommended that you use the Ethernet cable provided with the phone.
If inline power (PoE) is provided, you do not need to connect a power adapter. Make sure the switch
is PoE-compliant per the IEEE 802.3af standard.
Power Adapter
(DC 5V)
The phone may be powered using the optional ZULTYS 5V DC power adapter or via Power over Ethernet (PoE).
Your system administrator will advise which method to use.
PC (Optional)
Network
In hands-free mode
In headset mode
In handset mode
Mute activated
Ringer off
Call is on hold
Network Quality
Indicator
Received call(s)
Dialed call(s)
Network connected
Network disconnected
X
No IP address
!
Auto-answering activated
Call Forward activated
VLAN activated
Do not disturb activated (Red)
New Voicemail Messages
Keypad locked
Missed call(s)
Wireless network connected
Wireless network disconnected
Wireless network failure
Bluetooth device paired
Optional USB
Wi-Fi Adapter
4. Connecting to a wireless network:
To connect to a wireless network using the optional ZULTYS Wi-Fi Adapter, perform the following steps:
1. Connect the optional ZULTYS 5V DC power adapter and allow the phone to reach the idle screen.
2. Plug the ZULTYS Wi-Fi Adapter into the USB port on the rear of the phone.
3. When the phone displays ‘WLAN adapter is added’ press
OK
to scan for available networks.
4. Scroll down to ‘Available networks’ and press
Enter
.
5. Select the network you wish to connect to then press the
Link
button.
6. Enter the password and press
OK
. A green tick icon indicates a successful connection.
5. Connecting a Bluetooth headset:
To connect a compatible Bluetooth headset perform the following steps:
1. Select
Menu
>
Basic
>
Bluetooth
, set Bluetooth to
Enabled
and then press
OK
.
2. Place the Bluetooth headset into pairing mode then press
Scan
to locate the headset.
3. Select the headset from the list and then press
Link
to connect.
