INSTALLATION AND OWNER’S MANUAL
Carbon Fiber Kit: Z8300 for R1200 RT and
Z8302 for R1200R
Hand Held Hair Dryer, 1500 Watt
Mild Soap and Water for Cleaning
Small Scissors or knife
Tweezers for removing paper mask
Soft Cloth
CARBON FIBER KIT CONTENTS:
Part No.
Description
Qty.
Z8300 Kit
Main Dash Trim
2 piece
Rear Rack Trim
1 piece
Alcohol Pack
2
Z8302 Kit
Main Dash Trim
2 piece
Key Guard / Clamp Trim
3 piece
Rear Rack Trim
1 piece
Alcohol Pack
3
ZTechnik
PO Box Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.Z Technik.com / e mail: info@Z Technik.com
©2005 National Cycle, Inc.
Page 1 of 2 10-117794-000 08/05 Rev. A 01/07
PREPARATION
1.
Clean the motorcycle’s surface where the Carbon Fiber pieces
are to be placed with mild soap and water.
NOTE:
Cleaning is critical. Be sure to remove all wax, cleaners,
and protectants (Armor-All). These can contaminate the adhesive
causing it to fail.
2.
Dry area and clean again with the alcohol wipes.
Do not
apply
wax or polish to the area cleaned.
GENERAL INSTRUCTION
It’s best to read all general instruction, then proceed to spe-
cific points on page 2.
1.
Before removing the adhesive mask, familiarize yourself with
the fit of the the carbon piece to the area where it will be located.
CAUTION
-Do not use a heat gun or open flame to warm the Carbon Fiber
piece or the motorcycle, they produce too much heat and may
create a fire hazard.
-
Warming temperature is critical for the best performance and
adhesion. Installing a warm piece onto a cold surface is not rec-
ommended.
2.
Warm the motorcycles surface where the piece is to be placed
to about 100° F (37° C) (hair dryer).
3.
Warm the Carbon Fiber piece to 100° F (37° C) (hair dryer).
4.
When everything is warm, carefully remove the masking from
the adhesive side of the Carbon Fiber piece. (Do one piece at a
time) (tweezers).
5.
Position the piece in place.
6.
If it is necessary to reposition any piece, warm the piece and
slowly peel it from the surface. Be careful not to stretch or over
bend the piece.
7.
Once the pieces are correctly positioned, firmly but carefully,
press the pieces onto the warm surface. While still warm, careful-
ly use a soft cloth to press the piece onto the area until it is com-
pletely adhered.
9.
Avoid contact for 24 hours, the adhesive on the piece will have
set completely after that time and it will be permanently installed.
Z8300
Z8302
