ZXR10 T600/T1200 User Manual (IPv6 Volume)
St-
ep
Command
Function
ZXR10(config)#
router isis
This enters IS-IS
configuration mode.
ZXR10(config-router)#
is-type
{
level-1
|
level-2-only
|
level-1-2
}
This configures the routing
level for a router.
The default router is level-1–2
router.
ZXR10(config-router)#
ignore-lsp-errors
This sets the IS-ISv6 to ignore
the LSP checksum error.
ZXR10(config-router)#
metric-style
{
narrow
|
wide
}
This configures the metric
style of a router.
5
ZXR10(config-router)#
set-overload-bit
[
suppress
{
external
[
interlevel
]|
interlevel
[
external
]}|
on-startup
<
5-86400
>[
suppress
{
external
[
interlevel
]|
interlevel
[
external
]}]]
This sets the overload-bit in
the LSP packets sent by it.
ZXR10(config)#
router isis
This enters IS-IS
configuration mode.
ZXR10(config-router)#
redistribute
{{
bgp
|
connected
|
ospf
|
rip
|
static
}[[
level-1
|
level-2
|
level-1-2
]|
metric
<
0-63
>|[
external
|
internal
]]}
This configures route
redistribution, redistributing
routes of other protocols into
IS-ISv6.
6
ZXR10(config-router)#
summary-prefix X:X::X:X/
<
0~128
>[
level-1
|
level-1-2
|
level-2
]
This configures the IS-ISv6
routing aggregation and its
level.
The default is level-2.
Result:
Global parameters of IS-ISv6 protocol have been config-
ured.
Configuring IS-ISv6 Interface
Parameters
To configure interface parameters of IS-ISv6 protocol, perform the
following steps.
St-
ep
Command
Function
1
ZXR10(config)#
interface
<
interface-name
>
This enters interface
configuration mode.
ZXR10(config-if)#
circuit-type
{
level-1
|
level-1-2
|
level-2-only
}
This configures the IS-ISv6
circuit-type on an interface.
The default circuit type is
level-1–2.
2
46
Confidential and Proprietary Information of ZTE CORPORATION
Summary of Contents for ZXR10 T1200
Page 5: ...Figures 71 Tables 73 List of Glossary 75 ...
Page 6: ......
