ZXMW NR8120A/8120D Maintenance Guide
Parameter
Description
TTL
Sets the TTL of an LT packet.
TimeOut Time
Sets the timeout value for the remote end to send the LBR packet.
7.
In the left navigation tree, select
ETH > OAM_CFM > Operation Result Info
. The
Operation Result Info
pane is displayed on the right, including the functions of test,
LM, unidirectional DM, bidirectional DM, loopback test, and link trace.
Note:
For functions except unidirectional DM, the query result can be displayed until the
functions are implemented completely. Each query only displays the result of the latest
operation, and historical operation results will not be displayed.
a.
Select an MP record, which records the CFM operations of the MP, and click the
TEST
button. The query result is displayed, see
Figure 3-7 CFM Function Result Pane - TEST Button
For a description of the query result, refer to the following table.
Parameter
Description
Valid Result
1
indicates that the result is valid while
0
indicates that the result is
invalid. An invalid result indicates that unknown errors occur during the
calculation process, causing the result invalid. Normally, the displayed
query result is valid.
Source MP ID
Displays the MP ID configured for the end where the
Test Transmission
function is initiated.
Destination MAC
Displays the MAC address configured for the end where the
Test
Reception
function is initiated.
Bandwidth
Obtained through the CFM protocol packet test.
Throughput
Obtained through the CFM protocol packet test.
Number of Loss Packet
Displays the number of lost CFM protocol packets that are used for
the
TEST
function whose
Operator Type
is set to
Test Transmission
or
Test Reception
.
3-8
SJ-20150804150350-006|2015-09-17 (R1.0)
ZTE Proprietary and Confidential
