9
3
Configuration Preparation
3.1 Configuring TCP/IP
This procedure introduces how to configure TCP/IP for the ZXHN H108N device configuration.
Context
To ensure that the ZXHN H108N device accesses the ZXHN H108N successfully, configure the
computer address in the same network segment as the ZXHN H108N address.
The default network settings for the ZXHN H108N are as follows:
IP address: 192.168.1.254
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.254
Steps
1. Configure TCP/IP.
i.
In
Local Area Connection Properties
dialog box, select
Internet Protocol (TCP/IP)
.
ii.
Click
Properties
to open the
Internet Protocol (TCP/IP) Properties
dialog box.
iii.
In the
Internet Protocol (TCP/IP) Properties
dialog box, select
Use the following IP
address
. Set
IP address
,
Subnet mask
, and
Default gateway
. For example, set the IP
address to 192.168.1.7, the subnet mask to 255.255.255.0, and the default gateway to
192.168.1.1.
iv.
Click
OK
.
Note:
The settings may change with the network requirements. However, perform the steps above
at the first time.
2. Check the TCP/IP settings.
You can use the
Ping
command to check the connection between the computer and ZXHN H108N
device.
If pinging the device fails, verify the following:
The Ethernet cable between the ZXHN H108N device and the computer is not correctly
connected.
The ZXHN H108N device is not powered on.
