ZXDSL 931WII User Manual
Connection Procedure
1 Power OFF the equipment before all other devices are connected.
2 Connect the network cables: connect the RJ-45 Ethernet cable connector with the Ethernet interface of the ZXDSL 931 W
Ⅱ
. Connect other terminals to the Ethernet adapter of the user computers or ports of other network devices.
3 Connect the splitter.
The splitter has three interfaces, which are described as follows:
z
LINE: It is connected with the user telephone cable (RJ-11 interface).
z
MODEM (or VDSL): It is connected with the Line interface of the ZXDSL 931WII.
z
PHONE (or TEL): It is connected to the phone sets.
z
The installation process is as follows: Connect the Line interface of the ZXDSL 931WII to the splitter MODEM
interface by using the RJ-11 telephone cable. Connect the phone set lines to the splitter PHONE interface. Connect the
user telephone cable port to the splitter LINE interface.
4 Connect the power
Connect one power adapter terminal to the power interface of the ZXDSL 931WII, and the other terminal to the socket on the
wall. Then switch ON the ZXDSL 931WII equipment power.
Checking All Connection Cables
Check all connection cables according to the following steps:
1 Check the DSL cable connection
If the Link LED is ON normally, it indicates that the DSL line is correctly connected (Generally it takes one to two minutes to
perform the VDSL2 connection)
2 Check the computer connection
If both the computer Link LEDs are ON and the ZXDSL 931WII LAN LED is green, it indicates that the computer and the
ZXDSL 931WII equipment are correctly connected
.
3 Check the telephone cable connection
If the received telephone signals are normal and free of noise, it indicates the telephone cable is correctly connected. Power
ON/OFF status of the ZXDSL 931WII will not affect the telephone.
