H3140 Maintenance Management Guide
5.5 Configure the FTP Server Feature
Abstract
This procedure describes how to enable the
FTP
feature of the H3140 by configuring
FTP parameters, including the username and password.
Steps
1. In the left navigation tree, click
Local Network > FTP
. The FTP Application page is
Figure 5-24 FTP Page
2. Set the parameters. For a description of the parameters, refer to
.
Table 5-18 FTP Server Parameter Descriptions
Parameter
Description
Server
Enable or disable the FTP server feature .
FTP Username/FTP Pass-
word
Username and password used to connect to the FTP server.Valid
only if FTP security control is enabled.
3. Click
On
to enable the FTP server feature, and click
Apply
button to apply the
changes.
5.6 Configure the UPnP
Abstract
The
UPnP
function is used to support zero configuration, invisible networking, and auto-
matic discovery of vendor device types. After the UPnP function is configured, a device
can dynamically join a network to obtain its IP address, report its functions, and learn
about the functions of other devices.
Steps
Enable or Disable the UPnP Function
62
SJ-20210621164956-009 | 2021-12-07(R1.0)
Summary of Contents for H3140
Page 6: ...IV ...
