14295 Rev. 1.4 9/24/04
76
Ogo Manual
Place the device and the charger on a stable, level surface so it doesn’t fall, possibly
causing damage or injury. Do not place on or near a heat source or on an electrical
product that produces heat.
18.7. Device
Service
Bring your device, charger or accessories to the AT&T Wireless authorized service facility if
any of these have been dropped or damaged or have been exposed to liquid/water or
extreme heat.
Also, bring it in for service if any of these become very hot to the touch or do not operate
normally after following the instructions.
Do not disassemble the device, charger, or any accessories. Doing so could cause
further damage and could void the warranty.
18.8. Radio Frequency Signals
A wireless phone operates by sending and receiving Radio Frequency (RF) signals, and
therefore emits low levels of RF energy when the phone is on. Many studies have been
conducted concerning RF exposure.
Based on these studies, the U.S. Food and Drug Administration (FDA) has concluded that
the available scientific evidence doesn’t show that any health problems are associated with
using wireless devices, although there is no proof that they’re absolutely safe. Further
scientific research is ongoing, and AT&T Wireless supports this research. For more
information, you can review the FDA’s Consumer Update on Wireless Phones, which is
available from the FDA at 1 888 463-6332. Additional consumer information on wireless
phones and RF safety is available online at the joint FDA FCC Web site, Cell Phone Facts,
at
www.fda.gov/cellphones
.
The Federal Communications Commission (FCC) has established guidelines setting limits
for RF exposure from wireless phones (these limits are called the Specific Absorption Rate
or SAR). AT&T Wireless sells only those phones and devices that have been certified by the
manufacturers as complying with FCC guidelines. For more information about FCC
guidelines and SAR limits, you can visit the FCC’s Web site at
www.fcc.gov/cellphones
or
contact the FCC at 1 202 418-2464.
18.9. FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FCC ID:
SOW-0411CT10
Statement according to FCC part 15.21.
Modifications not expressly approved by CMCS could void the user’s authority to operate the
equipment.
Statement according to FCC part 15.105.
Summary of Contents for AT&T Ogo
Page 1: ......
