Plug the charger connector into the charge port at the bottom of the phone. (Note: Put upward the side with
arrow.) Then plug the other end of the charger in an appropriate electrical outlet.
Now, a charge indicator displays in the upper right corner of the screen. If the battery is charged in power-off
condition, the indicator bar will scroll. If the phone is over-used in shortage of battery or not used for a long time,
it will take a few minutes for the indicator bar to show.
When the battery is fully charged, the bar stops scrolling. Generally the whole charge process needs two to
three hours (charge the battery for six to eight hours for the first three times). During the charge process, your
phone, battery and charger may become hot, which is normal.
Disconnect the charger with the phone and the power outlet when charge finished.
Warning:
Put the phone at a ventilated place with temperature between
+
5
℃～
+
40
.
℃
Use only the supplied or
approved chargers. Using unauthorized charger may cause danger and violate the authorization and warranty
rules of the phone.
Charge the battery in time when your phone automatically powers off or displays a warning “Battery low”.
The conversation time and standby time of the phone lie on ideal working environments. In practice, the battery
working time varies with different network conditions, working environments and modes.
Connecting to the Network
SIM Card
Insert the SIM card (Subscriber Identity Module card) into the phone. This SIM card can be used by any GSM
mobile phone (A new phone can read the SIM card automatically).
Don’t touch the metal contact area of the SIM card. Doing so may cause information in the card lost or destroyed.
Keep the card away from electricity and magnetism.
Warning:
Power off your phone before changing the SIM card. It is forbidden to insert or remove the SIM card
when it is connected to an outer power source.
Inserting & Removing SIM Card
Switch off your phone, disconnect the outer power source and remove the battery.
Insert the SIM card into the SIM card slot or pull it out from the slot.
Switch on/off Your Phone
Hold the
End key
to power on/off the phone.
The mobile phone will automatically test whether the SIM card is plugged in and valid after power on, then the
following messages will be displayed on the screen sequentially.
：
Enter PIN 1
——
if a SIM card password has been set.
Enter phone code
——
if a handset lock code has been set.
Searching
——
search for the right network.
Unlocking the SIM Card and Mobile Phone
By setting a PIN 1 (personal identification number) code of the SIM card and the handset lock code, you can
10
