3
When installing a PCI Express x16 card, be sure the retention clip snaps and locks
the card into place. If the card is not seated properly, it could cause a short across the
pins. Secure the card’s metal bracket to the chassis back panel with the screw used
to hold the blank cover.
Jumper Setting
This chapter explains how to configure the motherboard’s hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this
chapter whenever in doubt.
Notice
:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be
seen even if the frequency multiplier setting in CMOS setup is changed.
If you want to clear the system configuration, use the JP1 (Clear CMOS Jumper) to clear data.
JP-CMOS Clear
JCMOS
Selection
1-2*
Normal*
2-3
CMOS Clear
Close Open
* = Default setting.
JP - P/S Port 5V Standby Power Selection
JP
Selection
1-2*
5V standby power input*
2-3
5V power input
