zortrax Endstop Sleeve, Installation Manual

Page: 3 / 12

The endstop sleeve is responsible for pressing the lever of the endstop once the
extruder reaches the end of the axis. This action immediately informs the printer
that the extruder should stop moving and not crash into the housing. Therefore, if
the extruder keeps hitting a corner of the housing, and an error message appears
on the display (Endstops error #034), check if the endstop sleeves are installed on
each axis block. The sleeves should be attached to the inner side of the axis
block. This manual gives instructions on the endstop sleeve installation. There is
an endstop sleeve model available for
download at the Zortrax Library.
The following manual shows the M200 repair work. For the M300, M200 Plus and M300
Plus, these procedures are the same.
page 3 / 12