Step 7: Putting It All Together
Make sure to plug in all of your connectors now.
You're going to have to essentially hook the right side
around and then push down. Don't push down right
away when initially trying to join the two pieces. Once
you've got the right side over the PCB and line it up with
the internal ring then you can push down and snap it
into place.
The back isn't ush by design. I am aware that it looks
sort of weird, but it was too di cult to pry open before I
changed it like this. The at spot also serves as the initial
contact point for the printing bed.
Once it's shut you can test all of your buttons. If you
want to use longer or shorter click pieces now is the time
to go back and check.
Now just do the last four screws and toss some feet on it.
ZS-X1, 3D Printed Endgame Gear XM1 Mini Guide: Page 10