The white paddles on the ZEN76 switch can be
replaced for a different color!
Please get in touch with our support to check which
colors are currently available and how to order
replacement paddles.
Zooz switches will match the shade of standard Leviton
switches and wall plates available at any major retailer.
MORE COLOR?
ZEN76 WIRING DIAGRAM FOR THE MOST COMMON 4-WAY INSTALLATION
ZEN76 WIRING DIAGRAMS FOR THE MOST COMMON 3-WAY INSTALLATIONS
For more diagrams or to request custom
instructions go to
support.getzooz.com
For more diagrams or to request custom
instructions go to
support.getzooz.com
Wire and screw position, as well as color codes are
for illustration only. You should not follow the
colors and positioning in the illustration blindly.
Always identify all wires prior to installing Zooz
switches and make sure you can match the
diagrams to your set-up exactly. Don’t experiment
or attempt a “trial-and-error” installation for your
own safety.
STOP!
NOTE!
If you are not comfortable identifying the wiring
and completing the installation, please consult a
licensed electrician.
Make sure you have identified all wiring correctly
before connecting the switch. If your wiring
doesn’t match any of the
below diagrams, contact
our support: [email protected]
ON/OFF SWITCHES ONLY
Do not connect Zooz Z-Wave switches to an
existing 3-way dimmer, illuminated switch, or an
electronic add-on switch.
Zooz switches can only
be wired with mechanical on/off switches in a 3-
way or 4-way setting!
To simplify the diagrams, we did not include
connections for the ground wire. Remember that
all Zooz switches need to be wired according to
the electrical code, with ground wire connected to
the ground terminal.
Always install your Zooz S2 switch in the box
with direct connection to power line.
Diagrams and instructions in this manual are
for ZEN76 and ZEN77 models ONLY!
NEED HELP?
If you’re having trouble reading the diagrams or don’t see
your wiring set-up here, get in touch! We have
more 3-way,
4-way, and 5-way diagrams
and instructions. There are
many ways to wire multi-point control set-ups so unless you
can match your wiring to the diagrams here, please don’t
attempt the installation for your own safety.
www.support.getzooz.com
[email protected]
The Simple Direct 3-Way/4-Way implemented in this device is a unique Z-
Wave multi-point control solution covered under U.S. Patent 10,219,353 B1.
ZEN76 / ZEN77
ZEN76 / ZEN77
ZEN76 / ZEN77
You can now easily check if the switch is within your Z-Wave hub’s
range:
Press and hold
the
lower paddle
for
10 seconds
until the LED
indicator starts blinking.
Release the paddle and within 2 seconds,
tap the lower paddle 2 times quickly.
The LED indicator will then
report signal strength.
Solid green =
direct communication with the primary controller is
stable
Flashing green =
direct communication with the primary controller is
established but signal is weak
Solid blue =
stable communication with hub via repeaters
Flashing blue =
communication with the primary controller is
established via repeaters but signal is weak
Solid red =
communication with the primary controller has failed
Tap
the
lower paddle
to
exit
testing mode.
NOTE:
This function may only be activated once the switch has been
included to a Z-Wave network.
RANGE TEST TOOL
