Zoom Studio 1204, Operation Manual

Page: 20 / 38

■
Switching between manual mode and memory mode
The currently active mode is shown by the MODE indicator. In manual mode, the indicator is on, and in memory
mode, the indicator is off.
In manual mode, all effect settings can be checked visually. This mode therefore is suitable for cases where
parameters of an effect are to be fine-adjusted in real time, such as during mix-down. The mode is also suitable if
you want to create a new effect from scratch.
The memory mode serves to instantly call up stored effect settings. This mode therefore is suitable for use during a
performance where effects are to be switched frequently. In this mode, it is also possible to edit a setting that has
been called up.
You can easily switch between the two modes as described below.
Switching from manual mode to memory mode
1. Verify that the MODE indicator is lit.
2. Press the MODE key on the front panel.
3. The MODE indicator goes out and the unit switches to memory mode.
The currently selected memory number appears on the display.
Switching from memory mode to manual mode
1. Verify that the MODE indicator is out.
2. Press the MODE key on the front panel.
3. The MODE indicator comes on and the unit switches to manual mode.
The currently selected effect type number and bank number appear on the display.
■
Calling up stored effect settings
Stored effect settings can be called up in the memory mode.Selecting a setting that is stored in the memory of the
1204 makes that setting active by electrically controlling the DSP (Digital Signal Processor) in the unit, but it does
not change the mechanical position of the front-panel controls including the BANK switch. Therefore the front-
panel controls may indicate a setting that is different from the actual effect setting that is active in the output.
When using the memory mode and not performing editing, the positions of the front-panel controls of the 1204
should be disregarded, except for the INPUT and OUTPUT level controls.
To call up a stored effect setting, proceed as follows.
1. Use the MODE switch to activate the memory mode.
2. The currently selected memory number is shown on the display.
3. Use the
▲
and
▼
keys to select the desired memory number.
Note: When wishing to change memory numbers quickly, first press the value key for the desired direction
and then hold down the other value key as well. The speed with which the memory numbers change
on the display will increase. When you are close to the desired memory number, release the other key
to reduce the speed again.
4. When you release the
▲
or
▼
(value) key, the setting stored in the currently displayed memory number
is called up and becomes active in the output.
Stored settings can also be called up via MIDI control. For details, please refer to page 21.
■ 19 ■