- 12 -
7. Press the [TYPE +] key of the transmitter and make sure that the 7 segment LED lit “tx”.
The indication flashes on and off at once. And the transmitter starts to send the data.
When sending and receiving finish successfully, and hexadecimals including two dots
such as [x.x.] appears on the display. This displayed [x] depends on User’s patch
conditions.
If [E1] or [E2] or [E3] appear on the display, these mean sending and receiving are error.
In this case, confirm conditions of the transmitter and receiver, and try to back up again.
8. Turn the both transmitter and receiver off.
9. Take the wires away and attach the bottom plate.
