124
Setting timecode
1.
Press .
2.
Use and
to select
TIMECODE
, and press
.
▶
Continue to one of the following procedures.
Setting the mode ………………………………………………………………… P. 125
Synchronizing audio clock with external timecode ………… P. 127
Automatically enabling internal timecode when no
external timecode is input ……………………………………………… P. 127
Setting the user bits for internal timecode ……………………… P. 128
Setting the frame rate for internal timecode …………………… P. 130
Jamming internal timecode ……………………………………………… P. 131
Restarting internal timecode with a specified value ……… P. 131
Mode
Use to set the timecode mode, timecode output when record-
ing is stopped, synchronization with audio clock, and internal
timecode operation when there is no external timecode input.
FPS
Use to set the frame rate of the internal timecode.
Jam
Use to set jamming of the timecode input through the TIME-
CODE IN/OUT jack by the internal timecode. This can be used
to restart the internal timecode at a chosen set value.
Ubits
Use to set the mode and content of user bits that can be
included in timecode.
Auto Rec
Delay
Use to set the amount of time until recording starts after time-
code is received.
Start TC
Use to set the value used when jamming timecode starts and
for calibration to increase the precision when jamming to RTC.
Summary of Contents for F6
