20
ADSL X3 User's Guide
Configuring the X3 Manually
Some users may need to configure the X3’s IP settings manually,
instead of having the modem automatically configure itself.
Typically, you would manually configure your modem if:
•
You already have the VPI, VCI, and Encapsulation settings
from your Internet service provider.
•
You have a static IP address that you plan to use with the X3.
If this is the case, skip this section and continue with Using
Static IP Addressing on page 23.
•
The auto configuration process was unable to find your
settings.
Manually configuring the modem requires that you log in to the
Zoom Configuration Manager and enter information on its
Basic Setup page. (If you need help logging in, see page 15.)
1111
On the Basic Setup page, ensure that the MANUAL option
button is selected.
2222
Do the following, depending on whether you know your VPI,
VCI, and Encapsulation settings:
!
If your Internet service provider gave you the settings,
continue with step 3 below.
!
If you do not know the settings, refer to the ADSL
Internet Settings Tables beginning on 43. Find your
service provider on the list and make note of its settings. If
there is more than one listing for your service provider, the
most common one is labeled (1), the next (2), and so on.
Tip:
If you are in the United States and your service provider is
not on the list, use the settings for Service Provider Not
Shown at the bottom of the table.
Summary of Contents for ADSL X3
Page 1: ...ADSL X3 U S E R S G U I D E...
Page 60: ...3364 A 27333 2004...
