4
6
In the
Install New Modem
screen, the correct modem will
be displayed. Fill in the
Location Information
screen if it
appears. Click
Next
.
7
At the
Modem Properties
box, select the newly installed
modem and then click
Properties
.
Set the
Maximum speed
to the highest speed available
(probably 115,200). This sets the speed at which the
computer communicates with the faxmodem.
Note:
Do not
check
Only connect at this speed
.
Click
OK
. Click
Close
.
Continue below with
Installing the Communications Software
.
Windows 95/98/Me/2000/XP
Turn your computer back on. Windows will detect your new
faxmodem and drivers and add the drivers to its database. If you
are using Windows 2000 or Me, you may see a dialog box
entitled Digital Signature Not Found; you can safely ignore this
screen and click
Yes
. If you are using Windows XP, you may see
a standard disclaimer dialog box regarding Windows logo
testing. You can safely disregard this message and click
Continue Anyway
.
Note:
If the Plug and Play setup does not proceed properly,
consult your full-length user’s manual.
Now you need to verify the faxmodem’s COM port setting. This
last operation also tests your faxmodem by querying it with AT
commands. The steps for Windows 95/98/Me and 2000/XP vary
slightly, as shown below.
Windows 95/98/Me:
1
Open
Start | Settings | Control Panel
. Double-click
Modems
. Fill in the
Location Information
screen if it
appears. Click on the entry for your new modem and click
Properties
.
2
Set the
Maximum speed
to the highest speed available
(probably 115,200).
Note:
Do not check
Only connect at
this speed
. Click
OK
.
3
Click the
Diagnostics
tab. Highlight the port next to the
entry for your new faxmodem and click
More info
.
4
Make a note of the
Port
and
Interrupt
entries under
Port
Information
. Click
OK
. Click
Close
. Close the
Control
Panel
.
Continue below with
Installing the Communications Software
.
