12 GB
Charging display
6
Status
Plug icon turns red and flashes
constantly
Charging is
in progress
Plug icon turns off
Charging is
complete
Plug icon turns red and flashes
3 times.
The battery level
is too low, so
that the product
cannot be
switched on.
Charging is
required.
Battery-status display
5
Status
Battery symbol turns red and
flashes
Battery level
is < 15 %. The
product is
operating.
Battery symbol turns red
Battery level is
< 15 %. Charg-
ing is in progress.
Battery symbol turns green
Battery level is
between 16 %
and 100 %.
The product is
operating or
charging is in
progress.
To avoid injuries and damage to the product,
always switch the product off by sliding the
ON/OFF switch
4
to the position with the
marking “0” is shown before charging the
battery.
Insert the cable plug of the plug-in mains adapter
8
into the socket on the lower part of the
product
7
.
Insert the plug-in mains adapter
8
into a socket
which meets the product requirements.
Disconnect the product from the plug-in mains
adapter
8
when the battery-status display
5
shows the red plug icon turns off and the green
battery symbol turns on (i.e. approx. 100 %
battery level).
Note:
Do not leave the product permanently
connected to the plug-in mains adapter
8
to
avoid damage to the battery or the product.
Note:
You can use the product for up to
approx. 60 minutes with a full battery.
Operation
Changing the comb attachments
on the cutting unit (see Fig. F + G)
Carefully place the desired comb attachment
9
onto the product as depicted in Fig. F. Ensure
that both recesses of the comb attachment
9
properly engage into the lateral detents at both
sides above the cutting unit
1
.
To remove the comb attachment
9
, press and
slide it forward and upwards using both thumbs.
CAUTION!
It is normal that the product will
become hot during use. Occasionally turn off
the product while using and check to see if
product has possibly gotten too hot for your
pet. If so, switch off the product to cool it down.
Setting the trim length
To set different trim lengths, hold the upper
part of the product
2
and twist the length
position indicator
3
into the desired position
(0.8–2.0 mm). The set trim length will be dis-
played on the length position indicator
3
which
aligns with the dot-marking on the upper part
of the product
2
.
Note:
Only cutting unit
1
can provide adjust-
ments on the trim length. The paw trimmer unit
15
cannot.
Trimming fur
Note:
The fur being trimmed should be clean,
dry and untangled.
Carefully comb the fur using the supplied styling
comb
14
to disentangle any potential knots.