ZoneVu ZVK-22D, User Manual

Page: 21 / 32

ZVK-22 User Manual
Issue 04 Page 21 of 32
MEYERTECH LIMITED
ZVK
-22D
Configuration
Keyboard Backup
The ZVK-22D keyboard can be backed up using
Meyertech’s
Mpower application. Backup is available through a site
controller or ZSC-250-xx and all the keyboards on a system can be backed up (one at a time) from a single point.
Engineer setup
Logging in as the engineer puts the ZVK-22D into the Engineer Setup menu. This menu is used to configure the
keyboard settings, usually at the time of commissioning.

Network Setup
Description Default
MAC address The module access code is the ZoneVu network address of ZVK-22D. Each item of
equipment on the network requires a unique address to function correctly.
5
Line Term. Line termination relates to the RS422 network. On a RS422 network system one item of
equipment should be terminated into 120R impedance, normally the last item of
equipment on the network. Note that only one item of equipment should be terminated Off
Mode
Stand-alone , when there is no video matrix or site controller present on the system.
This mode gives you the ability to control cameras directly from the ZVK-22D.
Network . In this mode the keyboard should be connected to either a ZoneVu video
matrix or a site controller
Network
Baud rate The baud rate for the communications: 9600,19200,38400 9600

Joystick Setup
The joystick employed in the ZVK-22D is a fully proportional X,Y,Z joystick providing the operator with independent
variable speed control of Pan, Tilt, Zoom, Focus and Iris functions.
Description Default
Centre stick Calibrate the joystick
Speed mode Basic or Advance
– Change this only following advise from Meyertech Technical
Support
Advance
Twist Sensitivity Alter the amount of movement required to start zooming or focusing
Set to low if you find the camera zooms / focuses accidentally. Standard
Note: Joystick Calibration
The joystick is a fully proportional type and, as such may require re-calibrating from time to time. To calibrate the
joystick.
1. Press the softkey directly adjacent to the menu option, Centre stick . A pop-
up window will say ‘Push any
key to begin’. Press any key and follow the menu instructions.
2. You will be asked in sequence to move the joystick fully right, left, up, down followed by zoom in and out via
the joystick twist grip.
3. Finally you will be asked to release the joystick to determine it
’s centre position.