Installation:
Hardware Installation :
1.Turn OFF the computer, unplug the power cord and open the computer
case.
2.Pick a free PCI bus master expansion slot and remove the expansion
slot cover. Insert the adapter into the slot until it is fully seated. Secure
the adapter.
3.Replace the computer cover and connect the network cable to the
newly installed network adapter. Reconnect the computer's power cord
and plug it into the power outlet.
Configuration:
The Zonet
ZEN3200
is automatically configured when you
power-on computer, In certain computer, however, you must modify BIOS
by entering CMOS ETUP utility to enable PCI Device and map INTA to
an appropriate address, Please refer to the system documentation for
details on configuration the PCI SYSTEM BIOS.
Driver Installation:
Before you connect adapter to the network, you have to install the
network driver first. The driver for each networking operating system is
under a separate directory. In the directory, there is a file describing
driver's installation procedure.
Boot ROM Installation:
The optional Boot ROM device allows you to connect a diskless
workstation to the network. Perform the following steps to install your
Boot ROM device:
1. Insert the Boot ROM into the socket on the adapter.
2. Refer to the installation procedure provided by networking operating
system (Options: Some adapters need to run SETUP Utility to enable
Boot ROM function)
12-086-00518 Rev:01
