4/10/2019
V4 User Manual and Installation Guide – Zonar Systems Support
https://support.zonarsystems.net/hc/en-us/articles/360017847851-V4-User-Manual-and-Installation-Guide
18/27
Drill, deburr, grommet, weather seal, and cable thru hole as required. Drill hole size - 1/2” (.500”); grommet size - 3/8”
(.375”).
Optional GPS Antenna Adhesive Tag (for non-magnetic mounting surfaces)
Whenever possible, avoid installing adhesive in cold, wet, or damp conditions. Ideal application range is: 70˚F to 100˚F
(21˚C to 38˚C).
1. Clean and dry the surface prior to placement to obtain optimum adhesion. The best surface cleaning solvent is an
isopropyl alcohol/water mixture (rubbing alcohol).
2. Remove the backing from the peel and stick to the surface.
3. Press and hold mounting position for 10 seconds to assure good adhesion.
GPS System Check
At a minimum, the installer must perform a system check to verify proper installation. If at all possible a full and
complete checkout using Zonar’s Ground Tra ic Control® website should be performed. Not all installers will have
access to this area; check with a Zonar Customer Service representative if in doubt. This procedure covers the
minimum requirements for a system installer.
Check the LEDs
Turn the key on, and with the engine running check the LEDs on the GPS unit within 2 minutes. They should display the
following sequence a er everything is connected.
LED
Condition
CELLULARSolid
green
. If blinking, ensure unit is an area with cellular coverage.
GPS
Solid
green
or
orange
. If blinking, the GPS is acquiring satellite positioning (antenna must have a clear view
to sky). Do not proceed further until GPS LED is solid.
STATUS
Solid
green
. If blinking, check the cables at the GPS unit and the vehicle connector. Also check the integrated
4 Pin power pigtail at the GPS unit. If the cables and the 4 Pin power pigtail are good, use a standalone 4 Pin
power cable.
Note
: STATUS will blink fast
red
when power is removed and the device is operating on internal backup
power.
Note
: STATUS will blink
blue
upon startup If Bluetooth is enabled while the device is in pairing mode.
DATALINK
1
Single
green
blink per second if J1708/J1587 data is present.
Single
green
blink per second if good communication between the Light Duty cable and the GPS device.