4/10/2019
V4 User Manual and Installation Guide – Zonar Systems Support
https://support.zonarsystems.net/hc/en-us/articles/360017847851-V4-User-Manual-and-Installation-Guide
15/27
Wiring Guidelines
The wiring guidelines in this section are for unterminated power and ground leads—4 Pin and Backbone. The
authorized method for power termination on the Zonar V4 system is the use of Add-a-Circuit fuse taps. Whenever
possible, use fuse taps for power termination. If fuse taps cannot be used due to the particular make/model/year of the
vehicle being installed, then the poke and weave method of termination can be utilized.
Note
: All wiring terminations MUST be fused regardless of method of installation used.
Fuse Taps Installation
1. Ensure that the fuse tap seats fully in the correct location.
2. If another fuse, a relay, or any other object in the fuse panel prevents the fuse tap from seating fully, relocate the
fuse tap.
It is not permissible for the fuse tap to rub or make contact with other items in the fuse panel
.
3. In addition, you must be able to re-secure the fuse panel cover or door once the fuse tap is installed.
4. Whenever possible, use an empty location in the fuse panel that does not have an existing fuse. If it is not possible
to use an empty location, ensure that the existing fuse is placed in the correct location on the fuse tap. See below
for an example.
