Using the hex wrench, extract the female wire con-
nector from the oval cutout in the pole.
Note
:
Remember to insert the female wire connector
back into the pole when disassembling Powersol.
A. Firmly insert the male wire connector into the female
wire connector.
B. Slide the male connector cap over the female con-
nector, and twist clockwise until tight. The male and fe-
male wire connectors are now firmly connected, forming
the wire assembly.
2
A
B
A
C
B
A
B
3
4
1
Keep oval
cutout below
charging tower!
Male wire
connector
Female wire
connector
A. Insert the pin into one of the three sets of pre-
drilled holes (depending on the desired table height),
until both ends of the pin protrude from either side of
the pole.
B. While feeding the wire assembly into the oval
cutout of the pole, slide the charging tower down-
ward.
C. Firmly insert the two protruding ends of the pin
into the slots in the bottom of the charging tower.
A. Slide the top locking cap up from bottom of the pole,
past the oval cutout.
B. Slide the charging tower up from the bottom of the
pole, past the oval cutout.
