LifeBand
Cover Plate
Tail End
Head End
Band Clip
Guide Plate
2
1
2
1
AutoPulse is a trademark of ZOLL Circulation
ZOLL Circulation ©2009 Printed in U.S.A.
P/N 10596-001 Rev. 10
Removing LifeBand
Installing new LifeBand
• Place AutoPulse face down.
• Lift hinged skirts, pinch 4
locking tabs and remove
Cover Plate.
• Grasp the Band with the
thumb and index finger of
both hands. Push in the
Guide Plate, using both
middle fingers and, pull up
the Band to remove the clip
from the shaft.
• Match arrow on the Cover
Plate with arrow on Platform.
• Insert Head end of Band
Clip into slot. Press Tail
end of Band Clip into Guide
Plate slot and feel for "click."
Rotate shaft in either direction
to verify Band Clip is seated
in slot. Ensure that Band is
not twisted.
• Snap Cover Plate in place and
flip down hinged skirts.
• Important: power on AutoPulse. If
a Fault/User Advisory is displayed,
check installation of the Band Clip
into the Drive Shaft slot.
LifeBand
®
Load-distributing Band
2
1
2
1
AutoPulse deployment on other side
AutoPulse
®
Quick Reference Guide
0344
Inquiries to:
ZOLL Circulation
650 Almanor Avenue
Sunnyvale, CA 94085 U.S.A.
t: +1.800.321.4CPR (4277)
t: +1.408.541.2140
f: +1.408.541.1030
EU Authorized Representative
ZOLL International Holding B.V.
Newtonweg 18
6662 PV ELST
The Netherlands
t: +31 481 366410