Zoeller APak Quick Start Manual Download Page 4

© Copyright 2020 Zoeller Company All rights reserved.

MAIL TO:

  P.O. BOX 16347 • Louisville, KY  40256-0347

SHIP TO:

  3649 Cane Run Road • Louisville, KY  40211-

1961

(502) 778-2731 • 1 (800) 928-PUMP • 

FAX

 (502) 774-3624

Visit our web site:

zoeller.com

Manufacturer warrants, to the purchaser and subsequent owner during   

the warranty period, every new product to be free from defects in material 

and workmanship under normal use and service, when properly used and 

maintained, for a period of 5 years from date of purchase by the end user. 

Parts that fail within the warranty period, that inspections determine to 

be defective in material or workmanship, will be repaired, replaced or 

remanufactured at Manufacturer’s option, provided however, that by so 

doing we will not be obligated to replace an entire assembly, the entire 

mechanism or the complete unit. No allowance will be made for shipping 

charges, damages, labor or other charges that may occur due to product 

failure, repair or replacement.

This warranty does not apply to and there shall be no warranty for any 

material or product that has been disassembled without prior approval of 

Manufacturer, subjected to misuse, misapplication, neglect, alteration, 

accident or uncontrollable act of nature; that has not been installed, 

operated or maintained in accordance with Manufacturer’s installation 

instructions; that has been exposed to outside substances including but 

not limited to the following: sand, gravel, cement, mud, tar, hydrocarbons, 

hydrocarbon derivatives (oil, gasoline, solvents, etc.), or other abrasive or 

corrosive substances, wash towels or feminine sanitary products, etc. in 

all pumping applications. The warranty set out in the paragraph above is 

LIMITED WARRANTY

in lieu of all other warranties expressed or implied; and we do not authorize 

any

 

representative or other person to assume for us any 

other liability in connection with our products.

Contact Manufacturer at, 3649 Cane Run Road – Louisville, KY 40211-1961, 

Attention: Customer Support Department to obtain any needed repair or 

replacement of part(s) or additional information pertaining to our warranty.

MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR SPECIAL, 

CONSEQUENTIAL OR INCIDENTAL DAMAGES OR BREACH OF EXPRESSED 

OR IMPLIED WARRANTY; AND ANY IMPLIED WARRANTY OF FITNESS FOR 

A PARTICULAR PURPOSE AND OF MERCHANTABILITY SHALL BE LIMITED 

TO THE DURATION OF THE EXPRESSED WARRANTY.

Some states do not allow limitations on the duration of an implied warranty, 

so the above limitation may not apply to you. Some states do not allow the 

exclusion or limitation of incidental or consequential damages, so the above 

limitation or exclusion may not apply to you.

This warranty gives you specific legal rights and you may also have other 

rights which vary from state to state. 

Summary of Contents for APak

Page 1: ...fficient to accommodate the appropriate conduit adapter Follow guidelines to ensure a water tight fit where applicable 2 Install unit in desired location using mounting flanges on enclosure 3 Remove the 4 cover screws to access the terminal contacts and the auxiliary contacts 4 Wire line and neutral to terminal contacts 1 2 and connect earth ground to the ground lug located on metal backplate See ...

Page 2: ...tallation by lifting the float manually The alarm unit will indicate an alarm condition by buzzer chirping and lighting the red LEDs The alarm may be silenced for 24 hours by briefly pressing the Silence toggle switch Once silenced the Red LEDs will remain on but the buzzer will not sound Once the high water condition is remedied the alarm should be reset by holding the Silence toggle switch for 2...

Page 3: ...e of motion IN A LIFT PUMP Install float switch at a level above where the pump will energize If a pump failure causes high level condition the APak Outdoor High Water Alarm System will activate see Figure A IN A HOLDING TANK Suspend float switch into tank 7 17 8 cm below desired alarm level APak Outdoor High Water Alarm System will activate if float ascends to alarm level see Figure D Model Numbe...

Page 4: ...accordance with Manufacturer s installation instructions that has been exposed to outside substances including but not limited to the following sand gravel cement mud tar hydrocarbons hydrocarbon derivatives oil gasoline solvents etc or other abrasive or corrosive substances wash towels or feminine sanitary products etc in all pumping applications The warranty set out in the paragraph above is LIM...

Reviews: