4
© Copyright 2017 Zoeller Co. All rights reserved.
STEP 1
Determine Installation Configuration
Figure 1
1. Figure 1 is a typical configuration for installation of the drain
systems. The actual configuration will vary depending on your
cabinet and sink configuration.
STEP 2
Install the Discharge Pipe onto the Pump
Figure 2
SK2367
SK2002B
BE SURE THAT WEEPHOLE
IS NOT DIRECTED TOWARD THE FLOAT!
Water stream will be visible from this hole during pump run periods.
PIPING SHOWN ONLY
FOR CLARITY.
DISCHARGE PIPE
PUMP DISCHARGE
WEEP HOLE
IMPORTANT
STEP 3
Installation of the Foam Gasket
3.1)
Install the foam gasket on to the “gasket surface” at the top of the basin, refer to Figure 4.1 for details.
Figure 3
SK2368
GASKET SEAL DETAIL
OVERLAP DETAIL
1/4
GASKET SEAL MUST BE
PLACED INSIDE OF HOLE
APPROXIMATELY 6 mm (1/4") OVERLAP
FOAM GASKET
GASKET SURFACE
FOAM GASKET
BASIN