Connect the Cleaner
1.
Submerge the cleaner and flood it
with water.
2.
When bubbles stop coming from the
extension pipe, connect the hose to
the cleaner.
3.
Turn on the filtration system and fill the
hose with water by placing the end in
front of a return inlet until it is flooded.
Turn off the pump.
Connect the Hose
The FlowKeeper Valve must be used on all
installations
. The valve regulates flow to ensure
the pool pump and cleaner run properly. It is pre-set
at the factory to optimize the performance of the
cleaner, but offers three settings to adjust the flow.
The lower the setting number, the lower the flow.
To adjust, pull the handle and move setting up
or down. The red tab can be used to open the
valve and stop the cleaner.
Install the FlowKeeper Valve with the arrow
facing down
towards the skimmer pipe.
Using the parts as indicated, connect the hose
to the skimmer. Be sure to keep the hose and
cleaner completely submerged to keep air out
of the system.
Once the hose is connected, turn on the
pool pump and begin cleaning. Installation
is complete.
5
FlowKeeper
Adjustment
45 Elbow
45 Elbow
4-1/2"
Connector
FlowKeeper
Valve
Valve
Cuff
FlowK
Va
4-1/2"
Connector
Hose
Protector
Net
Skimmer Installation
Summary of Contents for Wahoo
Page 1: ...Owner s Manual...
